Tips Guide

Types of Water Flosser Tips

Note: Not all tips are compatible with all Water Flossers.

Classic Jet Tip - For everyday use

JT-100 / JT-70

The Classic Jet Tip is the standard tip for everyday use. It cleans deep between teeth and below the gumline to help prevent gum disease and improve your oral health.

Best for: General use

Replace: Every 6 months

How to use: Start with the back teeth and follow the gumline, pausing briefly between the teeth and aiming the tip at the gumline at a 90-degree angle. Hold the tip slightly away from the gums to allow the water flow to remove plaque and debris.

 

See how the Classic Jet Tip works:

Orthodontic Tip - For braces, orthodontics

OD-100

The Orthodontic Tip has a tapered brush on the end to help remove plaque from braces and orthodontics. It also helps flush out bacteria and food debris from around teeth and under the gums.

Best for: Braces, Orthodontic Appliances, General Use

Replace: Every 3 months

How to use: Gently glide the tip along the gumline, pausing briefly to lightly brush the area between the teeth and all around the orthodontic bracket or appliance, then proceed to the next tooth.

 

See how the Orthodontic Tip works:

Plaque Seeker^® Tip - For dental work, implants

PS-100

The Plaque Seeker^® Tip removes plaque around all types of dental work and hard-to-reach areas. It has 3 thin tufts of bristles that gently access stubborn plaque around dental implants, crowns, bridges, and veneers.

Best for: Implants, Crowns, Bridges, General Use

Replace: Every 3 months

How to use: Place the tip close to the teeth so that the bristles are gently touching the teeth. As you water floss, gently glide the tip along the gumline, pausing briefly between teeth to gently brush and allow the water to flow between the teeth.

 

See how the Plaque Seeker^® Tip works:

Pik Pocket^TM Tip - For periodontal pockets

PP-100

The Pik Pocket^TM Tip is specifically designed to deliver water or anti-bacterial solutions deep into periodontal pockets as prescribed by your dental professional.

Best for: Periodontal Pockets, Furcations

Replace: Every 3 months

How to use: With the unit OFF, set the pressure to the lowest setting. Place the soft tip against the tooth at a 45-degree angle and gently place the tip under the gumline, into the pocket. Turn on power to clean.

Additional information:

• If the Pik Pocket^TM Tip separates from the shaft, do not use the tip.
• If you add therapeutic mouth rinse to the reservoir, run plain warm water through the unit and tip into the sink after use.

 

See how the Pik Pocket^TM Tip works:

Tongue Cleaner - For fresher breath

TC-100

The spoon-like shape of the Tongue Cleaner effectively traps and removes bacteria from the tongue to help prevent bad breath.

Best for: Fresher Breath

Replace: Every 6 months

How to use: With the unit OFF, set the pressure to the lowest setting. Place the Tongue Cleaner in the center/middle of your tongue, about half-way back. Turn on unit and pull the tip forward with light pressure. Repeat to clean the desired areas of the tongue. You can increase water pressure if you prefer.

 

See how the Tongue Cleaner Tip works:

Toothbrush Tip - For general use

TB-100

The Toothbrush Tip is similar to a manual toothbrush (it is not an electric or sonic toothbrush). It attaches to the Water Flosser handle and allows you to manually brush your teeth as you water floss.

Best for: General Use

Replace: Every 3 months

How to use: Use with or without toothpaste. Place the Toothbrush Tip in the mouth with the brush head on the tooth at the gumline. Using light pressure as you water floss, massage the brush back and forth with very short strokes, similar to using a manual toothbrush.

 

See how the Toothbrush Tip works:

Questions and Answers About Water Flosser Tips

Why should I replace a Water Flosser tip?

We recommend replacing the Classic Jet Tip and Tongue Cleaner every 6 months because mineral deposits can collect and reduce performance over time.

For tips with bristles, we recommend replacing every 3 months. Similar to a toothbrush, the bristles can splay, making the tip less effective. This applies to the Plaque Seeker^® Tip, Orthodontic Tip, Pik Pocket^TM Tip, and Toothbrush Tip.

To find and shop for compatible tips for a specific Waterpik^® Water Flosser model, click HERE!

How do I change a Water Flosser tip?

Every Water Flosser has a Tip Eject button, which allows you to remove the tip. If you are unsure of the location of the Tip Eject button, consult the Instruction Manual for your model HERE!

Note: When you insert a new tip into the Water Flosser, ensure it clicks into place. If the Water Flosser leaks from the base of the tip, turn off the unit and make sure the tip is firmly in place.

How do I clean Water Flosser tips?

To clean Water Flosser tips:

• Remove the tip from the unit using the eject button.
• Soak the Water Flosser tip in a container of hydrogen peroxide or white vinegar for 5-7 minutes.
• Rinse the tip under warm water.

For maximum effectiveness over time, we recommend replacing Water Flosser tips every 3-6 months.